Composite fabric information on maintenance and management of shuttleless loom temple devices

1. Maintenance
1. Installation and operation inspection
Before installation, the anti-rust oil needs to be removed from the shuttleless loom side support device, and the thorn tips should be checked for bruises, bends, and barbs. Copper thorn rings, Whether the polyurethane ring, rubber roller and steel licker-in can rotate flexibly. If there are any problems, they should be repaired or replaced. In addition, during installation, check whether the left and right side supports are installed incorrectly, whether the box cover touches the side supports and thorns, and whether the nuts are tightened.
2. Tour inspection
During the tour inspection, if the operator discovers problems such as side brace defects, chipped edges, broken edge yarns, etc., he should immediately notify the mechanic to inspect and replace the side brace device and spines. During the fabric width inspection, if narrow width, uneven tension of the left and right fabric edges and defects in the fabric edges are found, the temple device should be further checked or the position of the temple box should be adjusted.
3. Routine maintenance
If the thorn tips of the copper thorn ring are worn, they need to be replaced. If some of the thorn tips are bent or barbed, the bad steel needle can be removed and a new steel needle can be replaced in the original position. If the copper thorn ring The nylon bushing of the polyurethane ring is worn, causing the gap to increase. The same type of nylon bushing can be purchased and replaced. The rubber roller and steel lickerin roller bushings need to be replaced after wear.
2. Warehouse management
(1) After purchasing the shuttleless loom temple support device, it should be inspected one by one or randomly inspected for acceptance, and placed separately according to the variety and specifications to avoid mistaking them during use.
(2) Pay attention to the stacking order, master the principle of first-in-first-out, do not make the storage time too long, and check the quality every six months.
(3) After refurbishing the side supports and copper thorn rings that have been renovated or rotated out and not used temporarily, separate the left and right hands, apply anti-rust oil, wrap them in oil paper, and indicate the specifications and models on the In the box, copper thorn rings should not be stacked too much in each box. They should be handled with care to avoid damaging the thorn tips.
AAA flame retardant fabric network DFGRTJUYKYU